Many older boilers, gas fires, back boilers and warm-air heating units were vented through asbestos cement flue pipes running through cupboards, lofts and roofs. Carefully removing an intact AC flue is usually non-licensed work, provided it is not broken up, though it still requires trained operatives, controls and proper hazardous waste disposal. Flues are sometimes surrounded by insulating board or rope seals, which change the picture. We test and remove asbestos flues across Liverpool and Merseyside, usually ahead of a new boiler or loft work.
Where are asbestos flue pipes found?
Asbestos cement was a standard material for flue pipes for decades, and it appears wherever old heating appliances once vented. Typical places include:
- boiler cupboards and kitchens, where a round grey pipe rises from an old boiler into the ceiling;
- lofts, where the flue continues up and through the roof with a cowl or terminal on top;
- behind or above gas fires and back boilers, sometimes inside a chimney breast;
- warm-air heating systems, common in some post-war and 1960s–70s homes, where the flue and ducting may be made from different materials;
- outbuildings, garages and older commercial premises with heaters vented through the wall or roof.
Because asbestos may be present in any building built or refurbished before 2000, an old flue should be treated as suspect until it has been tested. Our asbestos testing service can confirm it.
Do not cut, drill, saw or snap an old flue pipe to get it out of the way, and do not let anyone remove it as part of a boiler strip-out until it has been checked. Leaving it undisturbed while you get advice is the right first step.
What should happen before a flue is removed?
A flue serves an appliance, so the appliance must be dealt with first. If a gas boiler or fire is still connected, it should be disconnected and made safe by a Gas Safe registered engineer before any work on the flue. Once the appliance is isolated, the flue can be assessed for asbestos and removal planned. We work around your heating installer's programme so the old flue is out before the new boiler is fitted, rather than the job stalling halfway.
Which category of work is flue removal?
Asbestos cement flues are in the same family as AC roof sheets and water tanks. If the flue can be removed intact, by releasing brackets and joints rather than smashing sections, the work is usually non-licensed. If it has to be broken up, the job usually becomes notifiable non-licensed work. The surrounding materials matter too:
| Material | Where it appears | Usual category |
|---|---|---|
| AC flue pipe, intact | Boiler cupboard, loft, roof | Non-licensed |
| AC flue that must be broken up | Tight lofts and chimney breasts | Usually NNLW |
| Rope seals and gaskets | Joints, appliance collars, old boiler doors | Non-licensed if removed largely intact |
| Asbestos insulating board | Boxing, fire protection around the flue, cupboard linings | Licensed for most removal |
That last line is why we look at the whole area rather than just the pipe. Board around a flue or lining a boiler cupboard is a different and higher-risk material; our asbestos insulating board page explains why AIB usually needs an HSE-licensed contractor. For more on the categories, see non-licensed and NNLW work.
How we remove an asbestos flue
- Questions first. We ask what appliance the flue served, whether it is still connected, where the flue runs, how it exits the roof or wall and what work is planned next.
- Check the surroundings. We look for board, rope seals and other materials around the flue, and arrange sampling where needed.
- Written quote. We explain the category, any notification and how the roof or wall opening will be left.
- Removal. Sections are dampened, brackets and joints released, and each length lowered whole wherever possible, working from the top down.
- Bagging and wrapping. Short lengths are double-bagged; longer lengths are wrapped in heavy-duty polythene and labelled.
- Disposal. Waste goes to a permitted site with a hazardous waste consignment note.
The hole left in the roof or wall needs weatherproofing. We will tell you clearly what we leave in place and what your roofer or builder needs to finish.
Flues in lofts with other asbestos
A loft with an old flue often has an asbestos cement water tank too, especially in houses where the heating was modernised in the 1960s and 70s. It is usually more efficient to deal with both in one visit; see our page on asbestos water tank removal. Our asbestos in the home guide lists other materials worth checking before a loft conversion.
Where we work
We remove old flues in homes and premises across Liverpool, Sefton, Knowsley, St Helens, Wirral and Halton. Post-war estates and new town housing, such as in Runcorn and Kirkby, often had warm-air or early central heating vented through AC flues, and Victorian terraces in places like Walton sometimes have a flue lined up inside an old chimney. As asbestos removal specialists on Merseyside, we plan the work around your installer.
What affects the cost?
Length and height of the flue, how it exits the building, access in the loft or cupboard, whether it can come out intact, any board or seals around it, testing, scaffold or roof access for the terminal, and waste volume. Our cost guide explains these factors. For everything else we cover, see our main asbestos removal page.
Old flue in the way of a new boiler?
Call 07777 659786 or send your details. Tell us what the flue served, where it runs and when your installer is booked, and we will call you back to arrange testing and removal.
Frequently asked questions
Can my boiler installer remove the old asbestos flue?
Some heating firms have trained staff for non-licensed asbestos work, but many do not, and they should not cut or break an AC flue to remove it. Any asbestos board around the flue usually needs an HSE-licensed contractor. Check with your installer early and, if they cannot handle it, we can remove the flue before they fit the new boiler.
How do I know if my flue is asbestos or metal?
Asbestos cement flues are usually grey, thick-walled and slightly rough, with visible joints or collars between lengths. Metal flues are thinner and often have a shiny or painted finish. Appearance is only a clue, and the pipe should not be scratched or knocked to check. Only laboratory analysis of a sample, by a UKAS-accredited lab, confirms whether the material contains asbestos.
Can an asbestos flue be left in place when a new boiler is fitted?
If the flue is intact, disconnected, capped and will not be disturbed, it may be left and recorded. That often happens with flues inside chimney breasts. If it is in the way of new pipework or loft boarding, or is damaged, removal is usually the better option. We will explain both options.
Is the rope seal on my old boiler asbestos?
Older boilers, fires and heaters often used rope seals and gaskets that may contain asbestos. HSE classes removing them largely intact as non-licensed work, but it still needs proper controls and disposal. Do not pull or scrape them out. Tell us about them when you call, and we will include them in the assessment.
Who weatherproofs the hole once the flue is removed?
Removing the flue leaves an opening in the roof or wall where the terminal was. We agree with you beforehand how the opening will be left, and a roofer or builder will normally carry out the permanent repair. Knowing this in advance means you can book the next trade in good time and the roof is not left exposed.