Asbestos Soffit and Fascia Removal in Liverpool

Planning new uPVC fascias and soffits on an older house? Find out what the existing boards are made of first. Some are asbestos cement, some are asbestos insulating board, and the difference decides how they must be removed.

Call 07777 659786

Get help with this

We only use your details to reply to this enquiry. Privacy policy

Soffits on houses built or refurbished before 2000 may contain asbestos. Some are asbestos cement (AC), which is usually non-licensed work if removed intact; others are asbestos insulating board (AIB), and most removal of AIB is licensable, meaning it must be done by an HSE-licensed contractor. Because the two look similar from the ground, the first step is a sample analysed by a UKAS-accredited laboratory. We arrange that testing, explain the result and plan the right kind of removal before your new fascias and soffits are fitted.

Why soffits are an asbestos question

The soffit is the board under the overhang of the roof, between the wall and the fascia that carries the gutter. From the 1950s through to the 1980s, flat sheet board was a common choice for soffits because it resisted rot and fire. Some of those boards were asbestos cement, a dense, hard material made of cement with asbestos fibres. Others were asbestos insulating board, a softer, lighter and more porous board that releases fibres much more easily when it is cut, broken or drilled. Timber and later fibre cement boards without asbestos were used too.

When a house gets new uPVC roofline products, the old soffits are either removed or covered over. Either way, it matters what they are. Our page on asbestos insulating board explains why HSE treats AIB so differently from cement.

Asbestos cement or AIB: how do you tell?

Reliably, you cannot without testing. There are rough clues: AC tends to be very hard, thin and brittle with a smooth grey face, while AIB is often thicker and softer and may be painted to match. But paint, weathering and later repairs make visual judgement unreliable, and pressing or scratching the board to check is exactly what you should not do. The only safe answer is asbestos sampling and testing: a small sample is taken under controlled conditions by a competent person and analysed by a UKAS-accredited laboratory to ISO/IEC 17025. The result tells you whether asbestos is present and what type of material it is.

Asbestos cement soffit AIB soffit
Typical feel Hard, dense, brittle Softer, lighter, more porous
Fibre release when damaged Lower, but still hazardous Much higher
Usual work category if removed intact Non-licensed Licensable for most removal
Who removes it Trained workers with controls HSE-licensed contractor
Notice before work None if non-licensed ASB5, at least 14 days

Should soffits be removed or covered over?

Covering, often called capping or overboarding, puts new uPVC over the old board. It can avoid disturbing asbestos, but it does not remove it: the material is still there, should be recorded, and anyone working on the roofline later needs to know. Fixing new boards through old ones also means drilling or screwing into them, which can release fibres. Many installers, and many homeowners, prefer the old boards to come out so the job is done once. Where soffits are sound and you want to keep them, encapsulation with a suitable sealant is another management option. We talk through the choices honestly; removal is not always the only sensible answer.

How we plan soffit removal

  1. Initial call. We ask the age of the house, how many elevations have soffits, whether new roofline is booked and if anything is already damaged.
  2. Testing. We arrange sampling, with analysis by a UKAS-accredited laboratory, and explain the result in plain English.
  3. Category and quote. AC soffits are usually planned as non-licensed work. AIB soffits are arranged through an HSE-licensed contractor, with the 14-day ASB5 notice built into the timetable. You receive a written quote.
  4. Access. Scaffold or suitable access is agreed; we coordinate with your roofline installer if they are providing it.
  5. Controlled removal. Boards are dampened, fixings released and boards lowered whole where possible, with sheeting below to catch debris.
  6. Waste and clearance. Waste is double-wrapped, labelled and taken under a hazardous waste consignment note to a permitted site. Where licensed work is involved, clearance by an independent UKAS-accredited analyst follows.

If you have roofline work booked, ask the installer what they plan to do with the old soffits and make sure they know asbestos may be present. Do not let anyone cut, rip out or drill old soffit boards until a sample result is back.

Soffits on Merseyside homes

Asbestos soffits turn up most often on houses from the post-war decades and on older houses whose roofline was renewed in the 1960s to 1980s. That includes many estates in Huyton and Kirkby, 1960s and 1970s new town housing in Runcorn, and semis in Maghull and West Derby. Blocks of maisonettes and low-rise flats may have long runs of board along walkways and balconies too, where landlords and managing agents have a duty to manage asbestos in the common parts. If you are a landlord with several properties of similar age, it is worth checking the roofline across all of them before planning upgrades.

Soffit jobs often go alongside other work on the outside of the house. Older properties may also have asbestos cement gutters and downpipes, or a cement flue terminal, and it can be efficient to deal with them in one visit. Our asbestos cement removal covers those items, and the whole job fits within our general asbestos removal service in Liverpool.

What affects the cost of soffit removal?

The biggest factor is whether the boards are AC or AIB, because AIB needs a licensed contractor, an enclosure-style approach and independent clearance. After that, cost depends on the length of roofline, the number of storeys, scaffolding, the condition of the boards, how they are fixed and the amount of waste. If scaffold is already up for roofline or roofing work, sharing it can help. Our cost guide sets out these factors, and we confirm prices in writing after testing.

Whatever the material turns out to be, the aim is that your new roofline goes on cleanly, the old boards are handled correctly, and you have paperwork showing where the waste went. If you are unsure where to start, a call with an asbestos specialist in Liverpool will clarify the next step.

Replacing fascias and soffits?

Call 07777 659786 or leave your details. Tell us roughly when the house was built and when the roofline work is booked, and we will call back to arrange testing and plan the removal.

Frequently asked questions

Do all old soffits contain asbestos?

No. Many older soffits are timber, and later boards are often fibre cement without asbestos. Some houses built or refurbished before 2000 do have asbestos cement or asbestos insulating board soffits. The only reliable way to know is a sample analysed by a UKAS-accredited laboratory.

Can uPVC fitters remove asbestos soffits?

Only if they have suitable asbestos training and controls, and only for non-licensed material such as intact asbestos cement. AIB soffits are licensable for most removal, so they must be removed by an HSE-licensed contractor. Ask your installer before work starts and get the boards tested first.

Is it safe to cover asbestos soffits with uPVC?

Covering can avoid disturbing material in good condition, but the asbestos stays in place, should be recorded and must be considered whenever the roofline is worked on again. Screwing new boards through old ones can also disturb it. We explain the pros and cons once the material has been identified.

How long does asbestos soffit removal take?

For asbestos cement soffits on a typical house, removal often fits within a day or two once access is in place, depending on length and condition. AIB soffits need ASB5 notification at least 14 days before licensed work starts, plus clearance afterwards. We give a realistic timetable after testing.

Are asbestos soffits dangerous if left alone?

Asbestos materials in good condition that will not be disturbed are often safest left in place and managed, according to HSE guidance. The risk comes from damage or work on them, such as cutting, drilling or breaking. Damaged or crumbling soffits should be assessed.

Call 07777 659786